If the filter frame and filter mesh are clogged with dust, the function of the air-conditioner may decrease 2.1 Cleaning of the filter frame and filter mesh 1). Page: 12/15 Clean the filter mesh once every two weeks. Water plug Drain cap Water outlet Figure 10 2. Turn on the unit only after the water plug and drain cap are installed properly otherwise, the condensate of the unit will flow onto the ground or carpet. Once the water is fully drained, insert the water plug and screw on the water cap tightly. Page: 11/15 plug as soon as possible to prevent the water from flowing onto the ground or carpet. Low button: press this button to allow this unit to operate in the low fan speed state 5. High button: press this button to allow the unit to operate in the high fan speed state (except in the dry and sleep modes) 4. Timer button: upon shutdown, press this button to set timed start upon start, press this button to set timed shutdown. Power button: press this button to turn on/off the unit 2. Page: 10/15 The operation instructions of the buttons of this simple remote control are as follows: 1. e).Up\Down Key: Press this two key to set the desired room temperature.(Press the Up key once, the temperature will increase by 1℃ or 1℉, also press the down key to decrease by 1℃ or 1℉), can also set the time in Timer Situation can also exchange from ℃ to ℉ display by pressing these two keys at the same time. Page: 9/15 After the Timer-Off or the Timer-On, the Timer indicator lights. Select the operation interface depending on the models and functions. Operation instructions of the control panel 1. The exhaust must be smooth and the air-conditioner may overheat if the exhaust is obstructed. Do not use prolonged hose or replace with other different hoses as this may affect the functions of the air-conditioner. Page: 8/15 specification of the air-conditioner (s). Figure 5 Figure 6 1.4 Installation of the unit 1). Pull apart the parts of the window sealing board assembly, adjust the distance of the window sealing board assembly pulled apart so that the two ends of the assembly come into contact with the window frame, and fasten the parts of the assembly with copper screws. Page: 7/15 either vertically or horizontally (as shown in Figure 5 and 6). When the end snap joint at the end of the rotation shaft of the back shell sticks out of the snap, it means that the heat exhaust hose snap has been slided into place. Page: 6/15 2) Point the rotary hole at the end of the heat exhaust hose snap toward the rotation shaft of the back shell and slide it onto the back shell in accordance with the snap joint direction of the rotation shaft on the back shell (as shown in Figure 1). C shape buckle of the heat exhaust hose snap 14. Handle position (right side: remote control storage area) 12. Function Description This series of mobile air-conditioners are available in cooling only and cooling & heating models of different sizes. Recommendation: Do not operate this unit if the ambient temperature is greater than 35℃ in the cooling mode or lower than 5℃ in the heating mode. Before cleaning the air-conditioner, be sure to turn off the power supply and wipe it with soft semi-wet cloth if the machine is indeed very dirty, wipe it with neutral cleaner. * Rated operating range: this unit shall be connected to 110-120V / 60Hz power output end. Important Safeguards Important safeguards: * This air-conditioner is suitable for indoor use only rather than for other occasions. Read the User’s Manual carefully before operating this unit. Please keep this User’s Manual properly for future reference. Page: 3/15 Thank you for selecting this super quality air-conditioner. User Manual Model No:EP23048 Voltage:115V/60Hz Power Consumption:970W
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |